Usually the car safety belt provides protection and safety for the passenger. However, in accident, when the passenger need to escape from the car, it might become obstacle. Most of the passenger can open the safety belt under normal condition easily and leave the car. But when the car falls into water by accident, the passengers in the car will be in big panic and they cannot open the safety belt, especially the old and children. Usually the car will pitch, roll and shake with the water when it falls into the water. All these cause trouble for the passenger to open the safety belt. Our Automatic Car Safety Belt Releaser-Escape Belt will provide an extra safety protection under this condition. When the car falls into water by accident, it will press the safety belt buckle release button and open the safety belt to free the passenger to escape. Fix the Automatic Safety Belt Releaser on the safety belt buckle. After the car fall in water, water will flow into the car by and by from the chassis to the top. When the water level comes to the safety belt buckle and meet the Automatic Safety Belt Releaser, the Automatic Safety Belt Releaser will act, the piston lever will come out and press the red safety belt release button and open the safety belt. The Automatic Safety Belt Releaser comes from Europe. It has been tested by TUV Germany.	1 2 3 4 5 6 7 8

It takes only a few simple step to install the Automatic Safety Belt Releaser in your car to provide an extra safety protection to the passengers.
1st step: assemble the Automatic Safety Belt Releaser it self

1.Take the 3 part out out the package	2.Put the House part with lever and the bracker part together, make sure that the rod on the house part is put in the slot on the bracket part

3. screw the water lock on the house part
2nd step: Fasten the Automatic Safety Belt Releaser on Safety Belt Buckle

1. Put the ribbon around the safety belt holder and make sure the upper wall of the bracket connected to the belt holder firmy.

2. Turn the screws clockwise one by one to fasten the escape belt on the seat belt holder..

3. Pull out the red lever part to check whether it will press the safety belt release button without obstruction. Please adjust the lever direction by turn the house part untile it is withou obstruction.

4.Put the lever pack	5.Screw the water lock tightly on the house part	6.finish the installation